The Mopar Performance PCM is designed for race applications on the 2008-2010 Viper, the Stage I Engine Controller has modified spark and fuel tables which function when “power adders” like headers, cat-back exhaust, aftermarket cams and cold air intake systems are used. The computer senses the additional air flow and will compensate with appropriate fuel and spark to maximize performance.The chassis dyno results showed a slight HP gain (approx 10 hp)on a stock ACR but the intent of this controller is to work with power adders to maximize performance. Features and Benefits: * Power adders can be used without turning on dash warning lights.Catalytic Converters and O2 sensors can be removed without tripping warning lights or causing limp mode to activate.* The revised fuel/spark tables are intended for power levels below 700 hp. This controller is not intended for use with nitrous, superchargers, or packages that go above 700 hp. It might work depending on your setup, but it wasn’t designed to function in that range.* Thefirst to fourth gearskip shift has been eliminated.* Requires the use of 93 octane fuel only.* The rev limit has been increased from 6400 rpm to 6500 rpm.* Tachometer settings have been adjusted for updates every 25 RPM (vs. every100 RPM).* Increases engine idle speed from 700 rpm to 750 rpm.* The ETC pedal / throttle MAP has been refined which improves pedal feel.* Tested using rear axle ratios between 3.07:1 to 4.10:1 NOTE: This device is not legal for use on pollution-controlled vehicles certified for use on streets or highways. Once this device is installed, use of the vehicle on a street or highway is a violation of the Clean Air Act, potentially subjecting the operator and the installer to civil penalties of up to $32,500 per vehicle depending on the circumstances.
Mopar Performance PCM for 08-10 Vipers